Cold storage board manufacturers tell you what is the development trend of cold storage board?

Since the reform and opening up, the total output value of my country's food industry has increased by more than 10% annually, but it is still far from social needs, providing a lot of space for the development of frozen food and fresh food. With the introduction and implementation of the "Agricultural Products Cold Chain Logistics Development Plan", it is expected that during the "Twelfth Five-Year Plan" period, my country's agricultural products cold chain logistics will achieve a substantial leap, and the refrigeration industry has also ushered in a critical period of large-scale development. With the upsurge of cold storage construction across the country, the large-scale construction of cold storage has further promoted the advancement of social refrigeration technology. At the same time, the wide application of new refrigeration technologies has further promoted the development of the refrigeration industry. According to a reporter from the Refrigeration Express, my country's industrial production demand and the increasing demand for refrigeration equipment-electronics, medicine, medical, bioengineering, aerospace and other occupations are closely related to refrigeration technology and equipment. For example, China's construction industry has a great demand for refrigeration equipment. In the construction of hydropower stations, concrete mixing, pre-cooling of sand and gravel, cold water mixed with concrete, and cooling of dams after irrigation require a large number of refrigeration equipment. Hydropower station construction is the main direction of power development in China. More refrigeration equipment is needed. At this stage, China's refrigeration industry should ensure the opportunity to establish modern logistics channels, continue to carry out and improve, the traditional near-bottom logistics into refrigerated supply chain logistics, change the traditional unreasonable form of work, to provide customers with better quality, higher value, more choices and greater flexibility.

The installation process of cold storage board manufacturers

Installation of wall panels for cold storage board manufacturers

1. Wall panel installation should start from the corner. According to the ship plate diagram, transport the two plates at the corners that need to be installed to the installation site, and drill holes in the middle of the plate width according to the angle iron part model of the fixed plate height and mushroom head nylon bolts. The drill bit should be perpendicular to the plate, and the mushroom head nylon bolt (nylon bolt and cream sealed in the mushroom head) should be worn in the hole, and the angle iron parts should be tightened, and the library plate should be tightened. When erecting the wallboard, soft materials such as foam shall be laid in the floor trough in contact with the warehouse board to prevent the warehouse board from being damaged. After the wallboard at two corners is neutral in the floor trough, the plane position of the wallboard and the verticality of the warehouse board shall be adjusted in time according to the position of the placement line. In addition, make sure that the top height of the wall panel is correct (always need to check). If the position of the wall plate is correct, weld the angle iron to the plate beam and fix the inner outer cover angle (put a sealing ointment on the inner side of the angle plate where it contacts the library plate). When welding angle iron parts, the original angle iron parts should be covered with a shield to prevent the high-temperature baking plate and welding residue from splashing on the steel plate during arc welding.

2. After installing the two wall panels at the corner, the cold storage board manufacturer starts to install the next wall panel along the corner. Before the next wall panel is installed, two white sealing pastes are applied to the floor (the sealing paste needs to match the convex shape or groove angle of the library board). The sealing paste in the convex groove or groove shape needs to have a certain height and be installed tightly and evenly in the same way as a wall panel.